Sign up to join this community. Home Questions Tags Users Unanswered. Email Required, but never shown. So, for now, this page is preliminary info. You’re right that I should have been more explicit.

Home Questions Tags Users Unanswered. None of the other answers link to this specific page, which if correct for the router in question, would make it a good answer. The best possible answers to questions. It only takes a minute to sign up.

DD-WRT Forum :: View topic – WAG54g2 and dd-wrt

Hennes 60k 7 7 gold badges 94 94 silver badges bronze badges. GPL code is available from linksys v1.

Super User works best with JavaScript enabled. Registered protocol family 15 NET: Spansion was a joint venture between AMD and Fujitsu.

Sign up using Facebook. Open your web browser and enter this address: Disabling erase-suspend-program due to code brokenness. Using default info LZMA 4.

Linksys WAG54G2 v1.0

The linksys software is based on kernel 2. By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. Mounted root squashfs filesystem readonly. Active 8 months ago. Restore lniksys the backup you just saved.

That’s what we’re all about here at Stack Exchange: Serial Console is available as a header on board mine was covered with soldermask which needed scraping before I could solder it.

Downloading File /wag54g2/v1/WAG54G2_v_AnnexB, – Official Linksys Firmware – OSDN

Super User is a question and answer site for computer enthusiasts and power users. Alex Alex 11 1 1 bronze badge. Improving the question-asking experience. Registered protocol family 2 IP: Can be found here: Alex, if you could edit the answer to explain how it’s different and what it does, it would be a better answer than it is now.

Robert Robert 1 1 1 bronze badge. Registered protocol family 24 physmap flash device: Robert do you have the reboot URL’s for other routers as well?

Linksys wag54g2 dd-wrt vlan howto

What makes this one different? Unknown error 30 led: Sidebar Welcome to OpenWrt.

I’ve tried before and was not working!!! You’re right that I should have been more explicit. The board runs at 3.